0 of 72 Preguntas completed
Preguntas:
Ya has completado el examen anteriormente. Por lo tanto no puedes iniciarlo de nuevo.
Cargando Examen…
Debes iniciar sesión o registrarte para empezar el examen.
En primer lugar debes completar esto:
0 de 72 Preguntas respondidas correctamente
Tu tiempo:
El tiempo ha pasado
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
An engineer must configure a /30 subnet between two routes. Which usable IP address and subnet mask combination meets this criteria?
Which network allows devices to communicate without the need to access the Internet?
Which of the following should be a characteristic of the core layer in the 3 tier topology?
Which Ethernet LAN contention or access method listens for a signal on the channel before transmitting data, and stops transmitting if a collision is detected?
What command was used to generate the output shown below?
What is the valid host address range for the subnet 172.25.4.0 /23?
Which statement is NOT true regarding Internet Control Message Protocol (ICMP)?
When packets are transmitted from one host to another across a routed segment, which two addresses are changed? (Choose two.)
In the diagram below, if the workstation at 10.0.1.3 sends a packet to the workstation at 10.1.1.3, what will be the source physical address when the packet arrives at 10.1.1.3?
Which of the following cables would be used to connect a router to a switch?
Which is NOT a valid range for private IP addresses?
You are creating a configuration to use on a switch. The configuration must enable you to remotely manage the switch.
Which of the following command sets is correct? (Assume the commands are executed at the correct prompt.)
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two.)
How do TCP and UDP differ in the way that they establish a connection between two endpoints?
Which statement identifies the functionality of virtual machines?
Which IPv6 address type provides communication between subnets and cannot route on the Internet?
Which IPv6 address block sends packets to a group address rather than a single address?
Which two statements about the purpose of the OSI model are accurate? (Choose two)
What is the destination MAC address of a broadcast frame?
In which way does a spine and-leaf architecture allow for scalability in a network when additional access ports are required?
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)
What is the function of a server?
What is a function of TFTP in network operations?
What are two functions of a server on a network? (Choose two)
What is the primary function of a Layer 3 device?
What is the same for both copper and fiber interfaces when using SFP modules?
Which function does the range of private IPv4 addresses perform?
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?
How do TCP and UDP differ in the way they provide reliability for delivery of packets?
What are two differences between optical-fiber cabling and copper cabling? (Choose two.)
What is the difference regarding reliability and communication type between TCP and UDP?
What are two descriptions of three-tier network topologies? (Choose two.)
Which type of IPv6 address is publicly routable in the same way as IPv4 public addresses?
What is the expected outcome when an EUI-64 address is generated?
A corporate office uses four floors in a building.
Which subnet summarizes and gives the most efficient distribution of IP addresses for the router configuration?
Refer to the exhibit. An engineer must add a subnet for a new office that will add 20 users to the network. Which IPv4 network and subnet mask combination does the engineer assign to minimize wasting addresses?
What is a characteristic of spine-and-leaf architecture?
An office has 8 floors with approximately 30-40 users per floor. What command must be configured on the router Switched Virtual Interface to use address space efficiently?
What is the name of the layer in the Cisco borderless switched network design that is considered to be the backbone used for high-speed connectivity and fault isolation?
A company needs to interconnect several branch offices across a metropolitan area. The network engineer is seeking a solution that provides high-speed converged traffic, including voice, video, and data on the same network infrastructure. The company also wants easy integration to their existing LAN infrastructure in their office locations. Which technology should be recommended?
Which WAN access technology is preferred for a small office / home office architecture?
Which two functions are performed by the core layer in a three-tier architecture? (Choose two)
Which function is performed by the collapsed core layer in a two-tier architecture?
An organization has decided to start using cloud-provided services. Which cloud service allows the organization to install its own operating system on a virtual machine?
Anycompany has decided to reduce its environmental footprint by reducing energy costs, moving to a smaller facility, and promoting telecommuting. What service or technology would support this requirement?
A network analyst is tasked with configuring the date and time on a router using EXEC mode.The date must be set to January 1,2020 and the time must be set to 12:00 am.what command should be used?
What are two fundamentals of virtualization? (Choose two)
What role does a hypervisor provide for each virtual machine in server virtualization?
A manager asks a network engineer to advise which cloud service models are used so employees do not have to waste their time installing, managing, and updating software which is only used occasionally. Which cloud service model does the engineer recommend?
How do TCP and UDP differ in the way they guarantee packet delivery?
What are two benefits of private IPv4 IP addresses? (Choose two.)
What are two benefits that the UDP protocol provide for application traffic? (Choose two.)
Which two goals reasons to implement private IPv4 addressing on your network? (Choose two.)
What is the binary pattern of unique ipv6 unique local address?
Refer to exhibit. Which statement explains the configuration error message that is received?
Which goal is achieved by the implementation of private IPv4 addressing on a network?
In which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?
Which two conditions must be met before SSH operates normally on a Cisco IOS switch? (Choose two.)
Refer to the exhibit. Which password must an engineer use to enter the enable mode?
Which command can you enter to allow Telnet to be supported in addition to SSH?
Which command is used to configure an IPv6 static default route?
Which command verifies whether any IPv6 ACLs are configured on a router?
Which IPv6 address type provides communication between subnets and cannot route on the Internet?
Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?
What is the expected outcome when an EUI-64 address is generated?
Which type of IPv6 address is publicly routable in the same way as IPv4 public addresses?
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?
A network engineer must back up 20 network router configurations globally within a customer environment. Which protocol allows the engineer to perform this function using the copy function?
What are two differences between optical-fiber cabling and copper cabling? (Choose two)