0 of 25 Preguntas completed
Preguntas:
Ya has completado el examen anteriormente. Por lo tanto no puedes iniciarlo de nuevo.
Cargando Examen…
Debes iniciar sesión o registrarte para empezar el examen.
En primer lugar debes completar esto:
0 de 25 Preguntas respondidas correctamente
Tu tiempo:
El tiempo ha pasado
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Refer to this output What is the logging severity level?
R1#Feb 14 37:15:12:429: %LINEPROTO-5-UPDOWN Line protocol on interface GigabitEthernet0/1. Change state to up
When using TLS for syslog, which configuration allows for secure and reliable transportation of messages to its default port?
Refer to exhibit. What are two reasons for IP SLA tracking failure? (Choose two )
Refer to the exhibit.
The IP SLA is configured in a router. An engineer must configure an EEM applet to shut down the interface and bring it back up when there is a problem with the IP SLA. Which configuration should the engineer use?
Which two statements about IP SLA are true? (Choose two)
Which IP SLA operation requires the IP SLA responder to be configured on the remote end?
A network engineer is configuring Flexible NetFlow and enters these commands:
Sampler Netflow1
mode random one-out-of 100
interface fastethernet 1/0
flow-sampler netflow1
Which are two results of implementing this feature instead of traditional NetFlow? (Choose two)
Refer to the exhibit.
Refer to the exhibit. How can you configure a second export destination for IP address 192.168.10.1?
configure terminal
ip flow-export destination 192.168.10.1 9991
ip flow-export version 9
A network is being migrated from IPv4 to IPv6 using a dual-stack approach. Network management is already 100% IPv6 enabled. In a dual-stack network with two dual-stack NetFlow collections, how many flow exporters are needed per network device in the flexible NetFlow configuration?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?
Refer to the exhibit.
These commands have been added to the configuration of a switch. Which command flags an error if it is added to this configuration?
Refer to the exhibit.
monitor session 1 source vlan 10 -12 rx
monitor session 1 destination interface gigabitethernet0/1
An engineer must configure a SPAN session. What is the effect of the configuration?
Refer to the exhibit.
What is the result when a technician adds the monitor session 1 destination remote vlan 223 command?
Which feature must be configured to allow packet capture over Layer 3 infrastructure?
Which statement about an RSPAN session configuration is true?
At which layer does Cisco DNA Center support REST controls?
Which two steps are required for a complete Cisco DNA Center upgrade? (Choose two)
Which tool is used in Cisco DNA Center to build generic configurations that are able to be applied on device with similar network settings?
Which devices does Cisco DNA Center configure when deploying an IP-based access control policy?
What does the Cisco DNA Center use to enable the delivery of applications through a network and to yield analytics for innovation?
An engineer uses the Design workflow to create a new network infrastructure in Cisco DNA Center. How is the physical network device hierarchy structured?
Which three methods does Cisco DNA Center use to discover devices? (Choose three)
Which two characteristics define the Intent API provided by Cisco DNA Center? (Choose two)
Which method does Cisco DNA Center use to allow management of non-Cisco devices through southbound protocols?