In a wireless Cisco SD-Access deployment, which roaming method is used when a user moves from one access point to another on a different access switch using a single WLC?

Which two pieces of information are necessary to compute SNR? (Choose two)

Refer to the exhibit.

The WLC administrator sees that the controller to which a roaming client associates has Mobility Role Anchor configured under Clients > Detail.

Which type of roaming is supported?

Which protocol is responsible for data plane forwarding in a Cisco SD-Access deployment?

Which tunneling technique is used when designing a Cisco SD-Access fabric data plane?

Which DNS lookup does an access point perform when attempting CAPWAP discovery?

Which statement about Cisco EAP-FAST is true?

Refer to the exhibit. Based on the configuration in this WLAN security setting. Which method can a client use to authenticate to the network?

What are two common sources of interference for WI-FI networks? (Choose two)

An engineer is configuring local web authentication on a WLAN. The engineer chooses the Authentication radio button under the Layer 3 Security options for Web Policy. Which device presents the web authentication for the WLAN?

Question 8

Which two descriptions of FlexConnect mode for Cisco APs are true? (Choose two)

When configuration WPA2 Enterprise on a WLAN, which additional security component configuration is required?

An engineer configures a WLAN with fast transition enabled. Some legacy clients fail to connect to this WLAN. Which feature allows the legacy clients to connect while still allowing other clients to use fast transition based on their OLTIs?

To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect?

A client device fails to see the enterprise SSID, but other devices are connected to it. What is the cause of this issue?

A customer has several small branches and wants to deploy a WI-FI solution with local management using CAPWAP. Which deployment model meets this requirement?

Which two methods are used by an AP that is trying to discover a wireless LAN controller? (Choose two)

Refer to the exhibit. Which type of antenna do the radiation patterns present?

When a wireless client roams between two different wireless controllers, a network connectivity outage is experience for a period of time. Which configuration issue would cause this problem?

Which access point mode allows a supported AP to function like a WLAN client would, associating and identifying client connectivity issues?

A client device roams between access points located on different floors in an atrium. The access points joined to the same controller and configuration in local mode. The access points are in different IP addresses, but the client VLAN in the group same. What type of roam occurs?

What does the LAP send when multiple WLCs respond to the CISCO_CAPWAP-CONTROLLER.localdomain hostname during the CAPWAP discovery and join process?

Assuming the WLC’s interfaces are not in the same subnet as the RADIUS server, which interface would the WLC use as the source for all RADIUS-related traffic?

Wireless users report frequent disconnections from the wireless network. While troubleshooting a network engineer finds that after the user a disconnect, the connection reestablishes automatically without any input required. The engineer also notices these message logs.

Which action reduces the user impact?

Which DHCP option helps lightweight APs find the IP address of a wireless LAN controller?

Why is an AP joining a different WLC than the one specified through option 43?

Which type of antenna does the radiation pattern represent?

What is calculated using the numerical values of the transmitter power level, cable loss and antenna gain?

What is used to measure the total output energy of a Wi-Fi device?

You are configuring a controller that runs Cisco IOS XE by using the CLI. Which three configuration options are used for 802.11w Protected Management Frames? (Choose three)

A wireless client is connecting to FlexAP1 which is currently working standalone mode. The AAA authentication process is returning the following AVPs:

Which three behaviors will the client experience? (Choose three)

Which antenna type should be used for a site-to-site wireless connection?

Using the EIRP formula, what parameter is subtracted to determine the EIRP value?

Refer to the exhibit.

Both controllers are in the same mobility group. Which result occurs when Client 1 roams between APs that are registered to different controllers in the same WLAN?

Which two sources cause interference for Wi-Fi networks? (Choose two)

Which DHCP option provides the CAPWAP APs with the address of the wireless controller(s)?

A wireless consultant is designing a high-density wireless network for a lecture hall for 1000 students. Which antenna type is recommended for this environment?

An engineer has deployed a single Cisco 5520 WLC with a management IP address of 172.16.50.5/24. The engineer must register 50 new Cisco AIR-CAP2802I-E-K9 access points to the WLC using DHCP option 43.

The access points are connected to a switch in VLAN 100 that uses the 172.16.100.0/24 subnet. The engineer has configured the DHCP scope on the switch as follows:

The access points are failing to join the wireless LAN controller. Which action resolves the issue?

Refer to the exhibit. Which level message does the WLC send to the syslog server?

What is the responsibility of a secondary WLC?

Which two methods are used to reduce the AP coverage area? (Choose two.)